GLS Shooting Logo
Disclosure
This website is a participant in the Amazon Services LLC Associates Program. We are reader-supported. If you buy something through links on our site, we may earn an affiliate commission at no additional cost to you. This doesn't affect which products are included in our content. It helps us pay to keep this site free to use while providing you with expertly-researched unbiased recommendations.
The Best

Scope Ring Height

Handpicked
Quality-Checked
Monstrum Offset Cantilever Picatinny Scope Rings | 1 inch...
  • Distinctive offset reversible design allows for added...
  • Mounts to any standard Picatinny rail mounting platform |...
  • High profile in height, 0.8 inches from base of mount to...

Read More About Scope Ring Height

Simple Tips to Adjust Your Scope Ring Height

What exactly is Scope Ring Height? How will it affect your ability to aim? Its size should ideally be very close to your goal lens. However, if the ring is too big, you will not get a good shot at your target. When shopping for a scope mount, please note how closely the various models fit the barrel of the rifle you plan to use it on. Also, make sure that the size of the scope corresponds to the bore length of the actual gun you plan to use it on.

There are two types of scopes: full tube and boresighter tube. The former features a significant portion of its line extending outward, while the latter features a small amount of its tube growing inward. The former type is more preferred over the latter because it gives you more height above the target. However, if you plan to carry a lot of heavier ammunition or elevate your weapon for long periods in combat, the entire tube is the better option.

To determine the correct scope ring height for your particular rifle, measure the distance between the front sight and the rear iron sights on your rifle as well as the distance between the front sight and the rear sights on the buffer tube. Add two inches to both measurements to get the final size. Now you need to make sure that your bore height is at least three inches to ensure that your shots are aligned. You can do this measurement in inches or calibers.

So how do you determine the correct ring size? One way is by shooting a few practice shots with your new gun to see how far the target goes through the shot. Using a measuring tape, note down the distance the target goes through the shot. Use the correct diameter of the scope ring so that your photos are consistent.

There are other ways to adjust your measurement. First, you can make use of the knobs on the side of the tube. You will know how much to change the tube to get the right degree of adjustment. If you can not find any knobs to adjust the setting, there are usually small rubber wheels located on the side of the scope that will allow you to change it.

Another way to adjust your scope rings is by making use of rifle reticle and scope rings. The reticle is what you see through the objective or the middle of the diamond mark on your sight picture. Once you learn how far your shot travels through the target, you can change the reticle to a larger one to get the proper scope ring height. It would help if you also got rid of the scope mounts. There are times that it is hard to keep the mounts secured onto the rifle.

When you find the best position to hold the scope in, make sure that the knobs on the side are aligned. In this way, the tube will be perfectly straight. Once this is done, turn the knobs clockwise to tighten the screws. When your scope ring height has been adjusted, the next thing that you need to do is to get the objective lens as close as possible to your mounting point. Make sure that the distance between the front and back glass is the same so that you can make sure that the sight picture is as straightforward as possible.

The final steps involve tightening the screws. Make sure to do this properly so that it will work well the next time you use the rifle. When you take a shot, you have to make sure that the scope rings align with the knobs on the tube. If you did it right, your shot would be obvious. Hopefully, these short tips will help you when you want to adjust the scope rings of your gun.